Products

Thermal adsorption type - uses part of the dried compressed air to purge the adsorbent after decompression to achieve "regeneration" of the adsorbent; Microthermal adsorption type - the difference from the non-thermal adsorption type is that the compressed air used for purging is heated by an electric heater.

The working principle of the pure oil-free screw compressor is the same as that of the normal pressure oil-free screw air compressor. The difference is that the low-pressure screw air compressor is equipped with a low-pressure stainless steel air end with a compression ratio of 1.2 to 4, and the air supply pressure of the unit is 1.2 to 4 bar. The unit has good stability and low energy consumption.

The advantages of the CMN oil-injected screw compressor are reflected in its outstanding energy-saving effect and variable frequency performance. The unit is equipped with a high-efficiency permanent magnet variable frequency motor and variable frequency drive, which automatically adjusts the speed to reduce energy consumption. Maintenance only requires replacing the filter element and air compressor oil. The CMN oil-injected screw air compressor is designed with no wearing parts, making maintenance simple and the designed service life is more than 20 years.

Relying on the low operating temperature of the air end, CMN, the hydrogen compressor manufacturers and suppliers, has developed a unique screw hydrogen compressor with a flow range of 5 to 59m3/min and a pressure range of 4 to 45bar. Since water is directly injected into the air end for compression, the operating temperature of the host will usually not be higher than 45 degrees Celsius, so safety can be guaranteed.

CMN oil-free carbon dioxide reciprocating compressor, the air end is made of 304 stainless steel. If there are special requirements for the co2 screw compressor, 316 stainless steel can also be used to prevent corrosion. The inlet pressure, outlet pressure, and exhaust volume can be designed as required.

Pure water instead of lubricating oil is used in the air end for lubrication. The air end and all parts in contact with water are made of 304 food-grade stainless steel. Compressed air passes the TUV oil-free test and also meets the requirements of the FDA and GMP. With no oil in the whole water-injected screw compressor, maintenance is simple and only requires the replacement of the air and water filter. Water-injected screw compressor adopts a direct coupling method between the air end and the motor, resulting in high transmission efficiency. The water-injected compressor unit operates at an exceptionally low temperature, typically around 45 degrees Celsius, ensuring efficient cooling and energy use.